Distillation Tester (low temperature single unit) LDT-A17 is a single distillation system with advanced refrigerator compressor. It is devised according to (Test Methods for Distillation Characteristics of Petroleum Products at Barometric Pressure) as per ASTM D86.
| Graduated flasks | 100 ml |
|---|---|
| Distillation flask | 125 mL |
| Ambient temperature | ≤ 30 °C |
| Relative humidity | ≤ 85 % |
| Temperature controlling range | 0 °C to 60 °C |
| Temperature controlling accuracy | ± 0.5 °C |
| Thermometer | (-2 )°C to 300 ℃ and (-2) °C to 400 ℃ |
| Division value | 1°C |
| Scale division | 1 ml |
| Inner diameter of electric furnace | φ32 mm, φ38 mm |
| Outer diameter of electric furnace | φ50 mm |
| Dimension | 720 x 590 x 660 mm |
| Heating power system | 1000 W |
| Total power consumption | ≤ 2500 W |
| Power supply | AC 220 V ± 10 %, 50 Hz |
It is used to determine distillation characteristics of gasoline, aviation gasoline, jet fuels, special boiling point solvent, naphtha, diesel oil, distillate and similar petroleum products.
| Ambient temperature | -10°C to 35°C |
| Relative humidity | ≤ 85 % |
| Thermometer | Each one for 70°C to 90°C , 100°C to120°C , and 125°C to 150°C |
| Scale division | 0.1 ℃ |
| Graduated flasks | 100 ml |
| Distillation flask | 125 ml |
| Ambient temperature | ≤ 35 °C |
| Relative humidity | ≤ 85 % |
| Heating power | 2 kW |
| Cooling power | 0.5 kW |
| Steam temperature | 0 to 400℃ |
| Oven temperature | 0 to 500℃ |
| Graduated flasks | 100 ml |
| Scale division of graduated flask | 1 ml |
| Outer diameter of distillation flask | φ65 |
| Refrigeration tube | φ14 |
| Distillation flask | 125 mL |
| Ambient temperature | Room temperature to 35 °C |
| Relative humidity | ≤ 85 % |
| Thermometer | (-2 )°C to 300 ℃ and (-2) °C to 400 ℃ |
| Graduated flasks | 100 ml |
| Scale division of graduated flask | 1ml |
| Distillation flask | 125 ml |
| Ambient temperature | ≤ 35 °C |
| Ambient temperature | 5 °C to 35 ℃ |
| Relative humidity | ≤ 85 % |
| Cubage of buffer vessel | 1000 ml |
| Max. Residual pressure | ≤ 2 mm Hg |
| Graduated flasks | 10 ml and 100 ml |
| Scale division of graduated flask | 10 ml is 0.1 ml and 100 ml is 1 ml |
| Ambient temperature | (-10) °C ~ 35 °C |
| Relative humidity | ≤ 85 % |
| Ambient Temperature Range | ≤ 35°C |
| Relative Humidity | ≤ 85% |
| Heating Mantle Cap Power | 1000 W |
| Sample Determination | 1 at a time |
| Ambient Temperature Range | ≤ 35°C |
| Relative Humidity | ≤ 85% |
| Heating Mantle Cap Power | 1000 W × 2 |
| Sample Determination | 2 at a time |
| Ambient Temperature | 10°C to 35°C |
| Measurement Range | 0 to 100 mg |
| Resolution | 0.1 µg |
| Max. Electrolysis Speed | 40 µg /s |
| Ambient temperature | 10 °C ~ 40 °C |
| Relative humidity | ≤ 80 % |
| Measurement Range | Ambient Temperature ~ 250 °C |
| Flash Point | Lower than 104 °C , error is 2 °C; Higher than 104 °C , error is 6 °C |
| Ambient temperature | ≤ 35 °C |
| Relative humidity | ≤ 85 % |
| Temperature range | 5 °C ~ 110 °C, Each scale division is 0.5 °C; 20 °C ~ 150 °C, Each scale division is 1.0 °C; 90 °C ~ 370 °C, Each scale division is 2 °C |
| Aperture of ignition device | 0.8 mm |
| Ambient temperature | 10 °C ~ 40 ℃ |
| Relative humidity | ≤ 80 % |
| Ignition Mode | electron igniter / gas flame |
| Temperature range | Room Temperature ~ 300 ℃ |
| Test bomb | Two samples or a group of parallel samples |
| Bath temperature | 37.8 °C |
| Temperature controlling accuracy | 0.1 °C |
| Dimensions | 500 × 560 × 680 mm, 950 × 540 × 720 mm |
| Operation temperature of water bath | RT ~ 90 °C |
| Temperature controlling accuracy | ± 0.1 °C |
| Dimensions | 550 × 520 × 102 mm |
| Pressure meter accuracy | ± 0.4 % kPa |
| Temperature measurement range | 10 ~ 35 ℃ |
| Repeatability error | ≤ 0.2 % (Grade C) |
| Endured pressure in oxygen bomb | 20 MPa |
| Operation environment temperature | 15 ~ 28 ℃ |
| Heat capacity | 14000 ~ 15000 J / K |
| Temperature measurement range | 10 ~ 35 ℃ |
| Repeatability error | ≤ 0.2 % (Grade C) |
| Endured pressure in oxygen bomb | 20 MPa |
| Temperature controlling range | 10 ℃ ~ 35 ℃ |
| Temperature resolution | 0.001 ℃ |
| Mean value of heat capacity | 15 kJ / K |
| Ambient temperature | 20 ℃ ± 5 ℃ |
| Temperature controlling accuracy | ± 0.5 ℃ |
| Refrigeration system | New-type refrigeration compressor |
| Cold trough | Two holes in one trough, and same temperature |
| Ambient temperature | ≤ 30 ℃ |
| Refrigeration system | New-type refrigeration compressor |
| Controlling temperature of cold trough | Cold trough I: RT ~ (-51) °C, ± 1°; Cold trough II:RT ~ (-80) °C, ± 1 °C |
| Ambient temperature | ≤ 30 ℃ |
| Relative humidity | ≤ 85 % |
| Ambient temperature | (-10)℃ ~ 35 ℃ |
| Relative humidity | ≤ 85 % |
| Sample cup Inner diameter | 31.0 ~ 32.0 mm |
| Sample cup Wall thickness | 1.0 ~ 1.5 mm |